Access Control/How To Setup DHI ASM100

How To Setup DHI-ASM100

Description

This step by step guide will run through the use of DHI-ASM100 with SmartPSS 1.16.1's access control section to assist in assigning 13.56 MHz MIFARE cards.

Prerequisites

• Windows 7/8.1/10 PC
• Error creating thumbnail: Unable to save thumbnail to destination
  SmartPSS 1.16.1
• DHI-ASM100
• DHI-ASC1204B/ASC1204C added to SmartPSS1.16.1

Step by Step Instructions

1. Connect the USB cable from the DHI-ASM100 to the Windows PC. Launch SmartPSS 1.16.1 then select ACCESS.

2. Single User Select the User tab on the top left, then select +Add. This is the area of SmartPSS 1.16.1 where you can add a new user to the ACCESS, in this page you can input:

• User ID
• Name
• Department (must be configured before)
• Card Type
• Card Password
• Unlock Password
• Validation Period
• 120KB picture

When you select Card No. the DHI-ASM100 will beep, when the light is greed it will read the card.

3. Batch User

A - User ID: Upper and lower case letters and numbers allowed, but no spaces.

B - Name: Upper and lower case letters, numbers, spaces allowed.

C - Card No.: this will be inputted with the card reader

D - Card Type: General Card - 13.65 mhz mifare