NVR/Basic Setup/Set IP Address
Revision as of 20:29, 3 December 2015 by Qi (talk | contribs) (→How to set IP address for configuring IP cameras)
How to set IP address for configuring IP cameras
Connect a RJ45 cable from camera to NVRThen connect a RJ45 cable from NVR to PC.
Go to wifi to be on the same network as the camera.
Go and find the IP address of the camera using the config tool.
Set the IP address of the laptop same as the camera.
Here's how:
Step 1:
Step 2:
Step 3:
Step 4: Make sure you put it on use the following IP address!
Then you can proceed to configure the camera such as an firmware upgrade.