NVR/Basic Setup/Set IP Address

How to set IP address for configuring IP cameras

Connect a RJ45 cable from the camera to your PC.

Go to wifi to be on the same network as the camera.

Go and find the IP address of the camera using the config tool.

Set the IP address of the laptop same as the camera.

Here's how: Open up network and sharing center

Step 1: Click on adapter settings

Step 2: Click on Ethernet

Step 3: Internet Protocol version 4

Step 4: Properties

Step 5: Make sure you put it on use the following IP address!

Then you can proceed to configure the camera such as an firmware upgrade.