SmartPSS/How To Use Two Way Audio

Revision as of 21:29, 2 April 2019 by Marques.Phillips (talk | contribs) (How To Use Two Way Audio In SmartPSS)

How To Use Two Way Audio In SmartPSS

Description

This article will show you how to setup and use Two Way Audio in SmartPSS 2.0

Prerequisites

  • SmartPSS
  • Device (IPC,DVR,NVR) with audio capabilities
  • Microphone added to device (if not built-in)
  • Microphone added to computer running SmartPSS
  • Device with audio capabilities added to SmartPSS Device List - How To Add Device to SmartPSS

Video Instructions


Step by Step Instructions

1. Launch SmartPSS.

Preset SmartPSS 1.jpg

2. Click 'Live View'

Preset SmartPSS 2.jpg

3. Double Click the Device on the device list on the left side of the screen, then double click the video pane to bring the feed up in full screen

Preset SmartPSS 3.jpg

4. Hover the mouse over the window to show the menu

How To Playback Local Record - 2.1.jpg

5. To listen to begin two way audio from this stream, click the Audio Talk icon Audio talk icon SmartPSS.jpg

To stop, click the icon again.


Note: If you receive the error "Failed to open audio talk. The audio from the local-end to the device is disabled!" make sure the microphone connected to the computer is recognized by Windows.

You can confirm this by going to Windows Control Panel>Sound>Recording

How To Use Two Way Audio SmartPSS - windows audio settings.jpg

Make sure the microphone is enabled and connected, then relaunch SmartPSS.