Software/Dahua Toolbox/VDPConfig/Upgrade Firmware

Revision as of 18:00, 10 June 2019 by Marques.Phillips (talk | contribs)

How To Upgrade Firmware In VDPConfig

Description

This guide will show you how to upgrade the firmware of a device using VDPConfig

Prerequisites

Step by Step Instructions

1. Open DahuaToolbox and click Open next to VDPConfig


Upgrade Firmware - VDPConfig - 1.jpg

2. Click the Upgrade icon on the left (Arrow)

Upgrade Firmware - VDPConfig - 2.jpg

3. Click Search Setting

Upgrade Firmware - VDPConfig - 3.jpg

4. Enter the password for the device

Upgrade Firmware - VDPConfig - 4.jpg

The window may refresh after entering a password

5. Check the box next to the device you wish to upgrade then click Browser to locate the firmware file

Upgrade Firmware - VDPConfig - 5.jpg

6. Use the window that appears to locate the firmware file

Upgrade Firmware - VDPConfig - 6.jpg

7. Click Upgrade

Upgrade Firmware - VDPConfig - 7.jpg

8. Upgrade Setup window will appear

Clear Config must be enabled.

Check the box next Clear Config then click OK to begin the upgrade

*Note if you are upgrading the firmware with a filetype other than bin make sure to adjust the dropdown box

Upgrade Firmware - VDPConfig - 8.jpg

9. The upgrade status will display via a progress bar

Upgrade Firmware - VDPConfig - 9.jpg

Upgrade Firmware - VDPConfig - 10.jpg


When the firmware upgrade is complete a green checkmark will appear next to the device

Upgrade Firmware - VDPConfig - 11.jpg