Template:IVS Tripwire WebUI Old

Description

Tripwire is used to trigger an alarm when a subject crossed the line in the defined direction, for example from A->B visa versa, or bidirectionally and snapshot,begin recording or activate an alarm.

Prerequisites

• Intelligent Network Camera or an HDCVI Camera that is connected to a HDCVI DVR that has intelligent features.
• Updated firmware that supports intelligent features.
• Internet Explorer.

Step By Step Instructions

1.Log into device using the Web Service.

2.Select Setting -> Event -> IVS.

3. Next to Rule Type click "+" in the new rule that shows below, define the Rule Name and in the drop down select "Tripwire" as the rule type

4. Once the rule is created and named, use "Draw Rule" to place your Tripwire line and under the "Direction drop down define in which direction, if only one, crossing is prohibited. In this example crossing from B -> A is prohibited.

5. Click "Setting" next to Period and a new window will appear. Here you can set the active time periods for the tripwire. By default the tripwire will be active 24/7. Each day can be edited individually or you can select multiple at once by checking the boxes and using the forms below to enter times. Up to 6 periods can be set for each day.

• 

  Setting Button

• 

  Setting Window

6. Next be sure to check any other options you may want such as Record & Record Delay, Snapshot, Relay out (1, 2, or both)alarm Delay and email. Note: For instructions on email setup see Email Setup. To record or save snapshots an SD card or recorder is required.

</br>

7. When finished click Save.