Solution Delivery/Integrating Video Intercom with Acccess Control

Revision as of 15:39, 8 October 2021 by William.V (talk | contribs) (Physical Wiring)

Description

This article will show how to wire the Normally Opened relay on the Video Intercom to the PUSH connection on our Access Control. This will act as a Request to Exit button when the door on the Video intercom is triggered.

The Video Intercom relays can be triggered from a VTH or through DMSS. In this tutorial we'll be using a siren/light to act as a door activating on Normally Open relay 1. We will be wiring the Normally Open Relay from the Video Intercom to "PUSH1" to act as a REX for NO1/NC1 on the access Controller


Prerequisites

  • Access Controller
  • Dahua Video Intercom Setup

Step by Step Instructions

Physical Wiring

1. Wire the Door_NO relay to the PUSH1 of the Access control and Wire the Door_COM from the Video Intercom to COM1 Access Controller

How to integrate video intercom with access control-1.jpg

2. Insert the connector to the Access Control

How to integrate video intercom with access control-2.jpg

3. Then Wire your door to your controller. Our "Door" is a Normally Opened device so we will wire the Door to NO1 and COM1

How to integrate video intercom with access control-3.jpg

How to open door via VTH

How to Open door via DMSS