Difference between revisions of "Troubleshoot/NVR/PTZ Troubleshoot"
| (10 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| − | Please Note: IP and HD-CVI PTZs do not require an | + | ==PTZ Troubleshoot== |
| + | Please Note: IP and HD-CVI PTZs do not require an RS485 cable. Controls are sent over the RG59 or CAT5 cable. | ||
| − | *Front panel PTZ error | + | * Front panel PTZ error |
| − | *PTZ decoder setup, connection or installation is not correct. | + | * PTZ decoder setup, connection or installation is not correct. |
| − | *Cable connection | + | * If using an RS485 Cable, the connection maybe reversed. |
| − | *PTZ setup | + | * PTZ setup with the Baud, protocol, and bit rate. |
| − | *PTZ decoder and NVR protocol is not compatible. | + | * PTZ decoder and NVR protocol is not compatible. |
| − | *PTZ decoder and NVR address is not compatible. | + | * PTZ decoder and NVR address is not compatible. |
| − | *When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable. | + | * When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable. |
| − | * | + | * To enter PTZ menu, right click and select PTZ and select OSD menu. |
| − | + | ||
| − | + | ||
| − | + | [[file:PTZ.jpg|250px]] | |
| − | + | ||
| − | + | ||
| − | + | [[Category:PTZ]][[Category:Troubleshoot]] | |
| − | |||
| − | |||
Latest revision as of 17:17, 3 May 2016
PTZ Troubleshoot
Please Note: IP and HD-CVI PTZs do not require an RS485 cable. Controls are sent over the RG59 or CAT5 cable.
- Front panel PTZ error
- PTZ decoder setup, connection or installation is not correct.
- If using an RS485 Cable, the connection maybe reversed.
- PTZ setup with the Baud, protocol, and bit rate.
- PTZ decoder and NVR protocol is not compatible.
- PTZ decoder and NVR address is not compatible.
- When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable.
- To enter PTZ menu, right click and select PTZ and select OSD menu.
