Difference between revisions of "Troubleshoot/NVR/Troubleshoot Date and Time"
m |
|||
| Line 24: | Line 24: | ||
[[file:DateandTimeTroubleshoot4.png]] | [[file:DateandTimeTroubleshoot4.png]] | ||
| − | [[Category: | + | |
| + | [[Category:Record Setup]] | ||
| + | [[Category:Troubleshoot]] | ||
Revision as of 16:45, 15 March 2016
How to set the date and time
Time display is not correct.
There are following possibilities:
- Setup is not correct
- Battery contact is not correct or voltage is too low.
- Crystal is broken.
1. Make sure the "Time Zone" is set correctly.
Error creating thumbnail: Unable to save thumbnail to destination
2. Setup DST, if applicable.
- Daylight Savings Time begins the 2nd week of March
- Daylight Savings Time ends the 1st week of November.
Error creating thumbnail: Unable to save thumbnail to destination
3. "Sync PC" if all else fails.
Error creating thumbnail: Unable to save thumbnail to destination
4. Click, "OK" to save your changes.
Error creating thumbnail: Unable to save thumbnail to destination
