Difference between revisions of "Access Control/How To Setup DHI ASR1101A"
(Created page with "==How to Setup DHI-ASR1101A==") |
(→How to Setup DHI-ASR1101A) |
||
| Line 1: | Line 1: | ||
| − | == | + | ===Prerequisites=== |
| + | |||
| + | * The DHI-ASR1101A unit and included hardware | ||
| + | * An RS485 ready controller capable of using this card reader (DHI-ASI1201A-D) | ||
| + | * Drill or screw driver | ||
| + | * Wires for alarm and light | ||
| + | * DC power supply for device | ||
| + | * Router or drill bits | ||
| + | |||
| + | ===Installation=== | ||
| + | |||
| + | 1. Drill out a hole where the wiring will enter the wall, and mount the supplied bracket. | ||
| + | |||
| + | 2. Connect the wiring according to what inputs and outputs you are configuring, here we will wire a 12VDC supply to the Red wire, Ground (GND) to the Black wire, RS485+ to the Purple wire, and RS485- to the Yellow wire. I am also wiring this device to the [[Access_Control/How_To_Setup_DHI_ASI1201A_D|DHI-ASI1201A-D]]. | ||
| + | |||
| + | [[File:ASR1101Asetup001.jpg|500x500px]] | ||
| + | |||
| + | 3. Make sure you have your card setup on the other controller and now give it a test from the DHI-ASR1101A. A Blue light means it is ready to scan, green means the read was successful, and red means the card was rejected. | ||
| + | |||
| + | [[File:ASR1101Asetup002.jpg|500x500px]] | ||
| + | |||
| + | [[File:ASR1101Asetup003.jpg|500x500px]] | ||
| + | |||
| + | [[File:ASR1101Asetup004.jpg|500x500px]] | ||
Revision as of 23:28, 15 June 2016
Prerequisites
- The DHI-ASR1101A unit and included hardware
- An RS485 ready controller capable of using this card reader (DHI-ASI1201A-D)
- Drill or screw driver
- Wires for alarm and light
- DC power supply for device
- Router or drill bits
Installation
1. Drill out a hole where the wiring will enter the wall, and mount the supplied bracket.
2. Connect the wiring according to what inputs and outputs you are configuring, here we will wire a 12VDC supply to the Red wire, Ground (GND) to the Black wire, RS485+ to the Purple wire, and RS485- to the Yellow wire. I am also wiring this device to the DHI-ASI1201A-D.
3. Make sure you have your card setup on the other controller and now give it a test from the DHI-ASR1101A. A Blue light means it is ready to scan, green means the read was successful, and red means the card was rejected.
