Difference between revisions of "Troubleshoot/NVR/PTZ Troubleshoot"
(Created page with "Please Note: IP and HD-CVI PTZs do not require an RS458 cable. Controls are sent over the RG59 or CAT5 cable. *Front panel PTZ error *PTZ decoder setup, connection or insta...") |
|||
| Line 7: | Line 7: | ||
*PTZ decoder and NVR protocol is not compatible. | *PTZ decoder and NVR protocol is not compatible. | ||
*PTZ decoder and NVR address is not compatible. | *PTZ decoder and NVR address is not compatible. | ||
| + | *When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable. | ||
| + | *The distance is too far. | ||
| + | *Front panel PTZ error | ||
| + | *PTZ decoder setup, connection or installation is not correct. | ||
| + | *Cable connection is not correct. | ||
| + | *PTZ setup is not correct. | ||
| + | *PTZ decoder and DVR protocol is not compatible. | ||
| + | *PTZ decoder and DVR address is not compatible. | ||
*When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable. | *When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable. | ||
*The distance is too far. | *The distance is too far. | ||
Revision as of 22:17, 5 October 2015
Please Note: IP and HD-CVI PTZs do not require an RS458 cable. Controls are sent over the RG59 or CAT5 cable.
- Front panel PTZ error
- PTZ decoder setup, connection or installation is not correct.
- Cable connection is not correct.
- PTZ setup is not correct.
- PTZ decoder and NVR protocol is not compatible.
- PTZ decoder and NVR address is not compatible.
- When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable.
- The distance is too far.
- Front panel PTZ error
- PTZ decoder setup, connection or installation is not correct.
- Cable connection is not correct.
- PTZ setup is not correct.
- PTZ decoder and DVR protocol is not compatible.
- PTZ decoder and DVR address is not compatible.
- When there are several decoders, please add 120 Ohm between the PTZ decoder A/B cables furthest end to delete the reverberation or impedance matching. Otherwise the PTZ control is not stable.
- The distance is too far.
