Alarm Out

Description

This feature will allow you to specify a range of time for a Dahua device to record when a physical alarm is triggered.

The following can trigger an Alarm Out from a Dahua IP Camera with the appropriate alarm outputs:

Motion Detection
Video Tamper
Scene Change
Audio Detection
IVS
Face Detection
Abnormality
- SD-Card
  - No DS-Card
  - SD Card Error
  - Capacity Warning
- Network
  - Disconnection
  - IP Conflict
- Illegal Access

The following can trigger an Alarm Out from a Dahua Recorder with the appropriate alarm outputs:

Physical Setup Instructions

Strobe and Buzzer(External Power)

Prerequisites

Step by Step Instructions

1. Here is your Electronic Buzzer, please read the product guide for this sensor to determine which lead is the power positive (ALARM OUT C1) and which lead is the Negative/Ground ⏚ in the event that the alarm is unidirectional and not bidirectional.

2. Also refer to the power requirements and specifications in order to make sure you are using the proper power supply unit for this device. Also Identify your power supply leads PSU+ and PSU- or Negative/Ground ⏚. PSU+ will go to ALARM OUT NO1.

3. Take the Electronic Buzzer and seat the positive lead it into the power block corresponding to ALARM OUT C1

4. Take the PSU and seat the positive lead it into the power block corresponding to ALARM OUT NO1

5. Now seat both the PSU and Electronic Buzzer's Negative/Ground ⏚ leads into any of the corresponding alarm out Negative/Ground ⏚ terminals on the NVR/HCVR/DVR

6. Now double check and make sure you have everything setup according to all of your device's (NVR/HCVR/DVR PSU and Electronic Buzzer) specifications. Also check that the leads are seated properly in the power block and are making full metal to metal contact with the power block.

7. Now Connect the power block to the corresponding ALARM OUT area, and plug in your power supply.

8. For testing purposes use this setup on your NVR/HCVR/DVR to make sure your setup works. Main Menu > Event (under settings) > click on Alarm tab > Enable Alarm > Select Alarm Out 1 > Enable Buzzer > click Apply.

9. Now trigger you magnetic sensor and you should hear the NVR/HCVR/DVR's Buzzer, and also now your Electronic Buzzer should be alarming out.

Now you know how to setup both alarm inputs (magnetic sensor) and powered alarm outputs (Electronic Buzzer)!

Please check all of your systems (NVR/HCVR/DVR PSU and Electronic Buzzer) power requirements and specifications before plugging things in without any understanding of how it works, as this can result in possible electrical fires or even the death of your systems (NVR/HCVR/DVR PSU and Electronic Buzzer).

Light (NVR Power)

Template:Alarm Record Physical Alarm Out2

Instructions

SystemUI Old

Prerequisites

Video Instructions

Step by Step Instructions

Brief Description: We will be setting up an Alarm Buzzer/Strobe light to the alarm output of our Recorder. It will be triggered by a Camera's Motion Detection Event.

1.Go to Main Menu

2. Click on Events

3. On "Alarm Output" we select the relay our Buzzer is connected to. In this case Relay 1. Click on Apply and then Ok to save.

4. Next select "Video Detection" on the left and check the Enable box.
- Check Alarm Out and select the relay the buzzer is connected to
- Check Record Channel and the channel you want to record to when the event it tripped
- Check Snapshot if you'd like to store snapshots

Click on Apply and Ok to save

5. Got back to the main menu and select Storage

6. Select Schedule on the left menu and click on the "settings" icon. On the pop up menu check "Alarm" and "All" for all days of the week. Hit OK to go back