Revision as of 16:34, 25 September 2019

ConfigTool Template Setup

Description

You can create and apply the templates.

• Creating the template: Back up or save the video and encoding parameters for the device.
• Applying the template: Restore or batch configuring the video and encoding parameters for the device.

These instructions do not copy the network settings or email notifications.

Prerequisites

For this example we will be using the following:

• 2x N41BK22s on DH_IPC-HX2X3X-Rhea_MultiLang_NP_Stream2_V2.800.0000008.0.R.190619
• ConfigTool Version V4.011.00GP001.0 from the Dahua ToolBox

Notes:

• N41BK22s on Firmware Version: 2.622.0000000.31.R Build Date: 2018-08-13 -DID NOT WORK, UPDATING BOTH IPCs to latest current fw and trying again

Template Examples

• 

  IPC Template

• 

  PTZ Template

• 

  DVR Template

• 

  NVR Template

Video Instructions

Export Device Config

Import Device Config

Step by Step Instructions

Export Device Config

1. Launch Toolbox, and login.

2. Download and install ConfigTool.

3. Launch ConfigTool.

4. Click on the icon at the bottom of the bar on the left hand side of ConfigTool.

5. Click on the Folder icon with the two green arrows.

6. A prompt will pop up asking, "Export template from device?" click, "OK"

7. Locate the device you want to export the configuration of in the device list, and left click on it.

8. Click, "Export"

9. A prompt will pop up asking, "Export template from (IP Address of Device Selected), continue? Click, "OK"

10. Input a name into the, "Template Name"

11. Click, "Save as"

At this point ConfigTool crashed. I relaunched ConfigTool, and get, "Export Template Failed"

12. A prompt will pop up asking where you would like to save the file. Select where you would like to save the file, and click, "OK"

Export Device Config

1. Launch Toolbox, and login.

2. Download and install ConfigTool.

3. Launch ConfigTool.

4. Click on the icon at the bottom of the bar on the left hand side of ConfigTool.

5. Click on the Folder icon without the two green arrows.

6. A window will pop up, click, "Browse" and locate the Device Template file you backed up in the previous instructions.

7. Click on the Device Template file, then click, "Open"

8. Click, "OK"

9. The template settings should load and display in ConfigTool. Verify that all the settings are correct.

10. Click, "Apply"

11. A window will pop up stating, "The file exists, do you want to overwrite it?" select, "OK"

12. Expand the dropdown box on the right hand side to list all the devices.

13. Check the box next to the device you wish to apply the template.

14. Click, "OK"

15. A window will pop up stating, "Configure 1 device(s) using template "C:/ProgramFiles/Toolsbox/Template_Name.xml" click, "OK"

NOTE: After this process is complete, you can check and verify which settings were transferred to the second camera by clicking on the orange exclamation point icon.